Re: OPLOT fails intermittently, any ideas?

[Reimar Bauer <r.bauer(at)fz-juelich.de>]

Which device are you using?
Z-Buffer?

regards
Reimar


Lawrence Bleau wrote:
> 
> In article <3B54747B.A6F1C983@fz-juelich.de>, Reimar Bauer <r.bauer@fz-juelich.de> writes:
> >
> >Hope I can give some hints
> >
> >max_value is a double but will be interpreted as float.
> >
> >a=9999998.
> [snip]
> 
> That is correct, but doesn't address the problem.  The typical data values are
> far, far below the value specified for max_value.  Unless you are postulating
> that a conversion from double to single will change the value by several orders
> of magnitude, this isn't the reason.
> 
> Typical Y data values to be plotted are between 1000. and 50000.
> 
> No, this is something subtler (or more obvious, depending on one's view).
> 
> Btw, the not-enough-data error occurred twice more yesterday.  We thought it
> was related to a gap in our data, but in these last two errors there was no
> gap, so that theory is shot down.  The IDL code in each of the last errors read
> in over 900 data points.  The same code reads in another 900 data points an
> hour later and plots them without error, though.  Really strange!
> 
> Lawrence Bleau
> University of Maryland
> Physics Dept., Space Physics Group
> 301-405-6223
> bleau@umtof.umd.edu

-- 
Reimar Bauer 

Institut fuer Stratosphaerische Chemie (ICG-1)
Forschungszentrum Juelich
email: R.Bauer@fz-juelich.de
http://www.fz-juelich.de/icg/icg1/
==================================================================
a IDL library at ForschungsZentrum Juelich
http://www.fz-juelich.de/icg/icg1/idl_icglib/idl_lib_intro.html

http://www.fz-juelich.de/zb/text/publikation/juel3786.html
==================================================================

read something about linux / windows
http://www.suse.de/de/news/hotnews/MS.html